Kawi2strokes.com Forum

Turns out "everything" involving the front brake system on my H2B is needing serious attention. I've found and ordered up most of what I need except, in my research, I can't get any consensus on the best replacement and source for the two brake lines.
Is there a preferred fairly accurate reproduction out there...and if so, where?
thanks

Slingshot Cycles was a good vendor but he is temporarily shut down.

http://slingshot-cycles.com/


Do you guys know of someone else that makes custom length brake lines?

_________________
H2B..... H1E..... Z1B ..... RD350...... X6 Hustler..... TS250.... CB750 ..... CB550...... and a Bomber!!

Spiegler does great work and can do custom lines to any length.

_________________
1972 Kawasaki H2 Mach IV (Candytone Blue),1984 Yamaha RZ350 (KRR- Yellow/Black), 2004 Honda Helix (Clipper Yellow).

“Jeff and Chris are THE MEN!”
RIP John E. Evans

Link to website or contact info? Thanks

_________________
H2B..... H1E..... Z1B ..... RD350...... X6 Hustler..... TS250.... CB750 ..... CB550...... and a Bomber!!

Hi,

here is the link to the german website http://www.spiegler.de/

Robby

_________________
Who´s braking later, drives longer fast !!!!!!

_______________________________________
RD125, S1B, S1B (350cm³), S2, S3A, H1B, H2, H2, S2-R, KR1S, NS400R [GSX-R1000K1, CBR1100XX, CB 750F1]

I had found a set pre made on ebay some time back. Works well.

_________________
Iron On The Bayou.

H1e

www.speiglarusa.com........they are about 5 miles from my house.......I went up and waited 20 min while they made my brake line

NOTE: I have the superbike low rise bars on my bike, maybe 3" rise, order this from Speigler, talk to Dave 937-291-1735 ($63)

NOTE: Below is for a single EX caliper hose......but this gives you an idea of how to order after you measure your lines (2 I beleive)

Left side 2" longer is 851mm-002-004 (002 is 20 degree, 004 is 45 degree)
Right side same as stock EX hose probably would be 800mm-002-004

THX Phil