Kawi2strokes.com Forum

Enthusiasts from around the world dedicated to the preservation and ritual flogging of the infamous Kawasaki 2-stroke Triples
It is currently Fri Jul 11, 2025 9:28 am

All times are UTC - 5 hours




Post new topic Reply to topic  [ 10 posts ] 
Author Message
 Post subject: engine won't run
PostPosted: Tue Aug 14, 2012 7:29 am 

Joined: Tue Aug 14, 2012 7:08 am
Posts: 2
Friend called and said his new engine build won't run. We have both been racing for over 40 years and I have never seen one of these engines that wouldn't start. Starts when fuel is sprayed in carbs, but as soon as fuel burns off, engine will only idle. Try to throttle up, engine dies. The only new part, from when the engine was last raced, is a new crank! checked index, found to be right. good spark, fresh fuel, timing right on. Bike went from 8:50s to not starting, after instaling new crank. Any Ideas.


Thanks


Top
 Profile  
 
 Post subject: Re: engine won't run
PostPosted: Tue Aug 14, 2012 8:26 am 
User avatar

Joined: Wed Jun 08, 2011 10:04 pm
Posts: 2223
Location: Just north of Toronto, Ontario
Maybe check the float levels and at the same time, make sure you have good fuel flow out of the tank.

_________________
:wtf: :wtf: :wtf:

http://kawatriple.com/wtf/


Top
 Profile  
 
 Post subject: Re: engine won't run
PostPosted: Tue Aug 14, 2012 10:46 am 

Joined: Tue Aug 14, 2012 7:08 am
Posts: 2
floats are good and electric pump. How would this thing act if the seals are bad?


Top
 Profile  
 
 Post subject: Re: engine won't run
PostPosted: Tue Aug 14, 2012 11:06 am 
Site Admin
User avatar

Joined: Tue Jun 07, 2011 6:37 am
Posts: 10460
Location: Rio Rancho, New Mexico
TURBO H2 wrote:
floats are good and electric pump. How would this thing act if the seals are bad?


It depends on how bad they are, if not totaled, it should start. Can you feel suction on the carb when turning over the motor? And did you clean the carbs, no idle is usually clogged pilot jets.....

_________________
Twist the throttle, tilt the horizon, and have a great time. What triples are all about...........


Top
 Profile  
 
 Post subject: Re: engine won't run
PostPosted: Tue Aug 14, 2012 9:01 pm 
User avatar

Joined: Wed Jun 08, 2011 10:08 pm
Posts: 1901
Location: Campbellville Ontario
There was another member who had a similar issue with a drag motor. It turned out to be bad lab seals on the rebuild. He did the crank again with rubber seals and....viola.


Top
 Profile  
 
 Post subject: Re: engine won't run
PostPosted: Tue Aug 14, 2012 10:44 pm 
User avatar

Joined: Sun Jul 17, 2011 8:26 pm
Posts: 227
Location: Breese, IL
If they are similar to stock carburetors, I have had this problem and it turned out to be when I slipped the throttle slides in the top of the carbs one of the cables slipped out of place to where when twisting the throttle only 2 slides went up.


Top
 Profile  
 
 Post subject: Re: engine won't run
PostPosted: Fri Aug 17, 2012 2:27 pm 
User avatar

Joined: Wed Jun 08, 2011 10:12 pm
Posts: 2169
MAKE SURE plug wires didnt get crossed. when it starts does it sound crap? if 1 & 3 are swapped it will fire but backfire and not 'run' for more than a second or 2.
seen that one happen a lot.


Top
 Profile  
 
 Post subject: Re: engine won't run
PostPosted: Fri Aug 17, 2012 9:10 pm 
User avatar

Joined: Wed Jun 08, 2011 10:28 pm
Posts: 1575
Location: Tampa Bay Florida
m in sc wrote:
MAKE SURE plug wires didnt get crossed. when it starts does it sound crap? if 1 & 3 are swapped it will fire but backfire and not 'run' for more than a second or 2.
seen that one happen a lot.

:oops: :oops: :oops:

_________________
We don't need no stinkin' Cams!


Top
 Profile  
 
 Post subject: Re: engine won't run
PostPosted: Sat Aug 18, 2012 7:20 am 
User avatar

Joined: Wed Jun 08, 2011 10:12 pm
Posts: 2169
hehe. forgot about that bill. had to deal with it again only a week ago on phils 'new' 74. I swear 30% of the bikes i have run across were parked for that reason after a rebuild. after we got phils bike firing right it was quiet as a sewing machine. crazy


Top
 Profile  
 
 Post subject: Re: engine won't run
PostPosted: Sat Aug 18, 2012 8:47 am 
User avatar

Joined: Wed Jun 08, 2011 10:28 pm
Posts: 1575
Location: Tampa Bay Florida
QUIET!?!? :o A set of chambers will fix that!!! :mrgreen:

_________________
We don't need no stinkin' Cams!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 10 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group