Kawi2strokes.com Forum

Enthusiasts from around the world dedicated to the preservation and ritual flogging of the infamous Kawasaki 2-stroke Triples
It is currently Thu Oct 31, 2024 7:16 pm

Board index » Our legendary Kawasaki Triples » Troubleshooting, How-to, and General Wrenching

All times are UTC - 5 hours




Post new topic Reply to topic  Page 3 of 3
  [ 22 posts ]  Go to page Previous  1, 2, 3
  Print view Previous topic | Next topic 
Author Message
Frank
PostPosted: Sat Dec 12, 2020 1:47 pm 

Joined: Sun Jun 12, 2011 7:15 pm
Posts: 307
Location: Maine
I was wrong (again, lol): I found the float pin on the floor about 6' from the bike. It must have slid out and bounced off stuff or something so the float was constrained.

What I did find however, was the sealant used to replace the gasket had gaps in it so I'm hoping that gas was bouncing around and out of the float bowl due to that. I'll find out soon.
Top
 Profile  
 
Jim
PostPosted: Sat Dec 12, 2020 2:04 pm 
User avatar

Joined: Wed Jun 08, 2011 11:34 pm
Posts: 9928
Location: North Central NC
:)

_________________
If it surges, that's normal, upshift.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 3 of 3
  [ 22 posts ]  Go to page Previous  1, 2, 3

Board index » Our legendary Kawasaki Triples » Troubleshooting, How-to, and General Wrenching

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group