What happened was Jim “Darth” and Steve “CrabbySteve” were making the lines, well Steve the lines and Jim taking care of the check valve part and making the new plastic ends, Steve had some personal issues and decided to disappear from the triple world and in doing so he took with him the knowledge that he had developed in making the lines.
Jim and I have figured out some of the big hurdles like what line to use, how to successfully heat and bend the sharp angles in the lines, along with sourcing the proper adhesive as nylon is very difficult to bond. At this point we have all the information and materials including all the old oil lines, cases and covers to make these again, at the current time our lives seem to be filled with very little time and or interest and things always seem to get started and pushed to the back burner, hopefully this winter we can devote more time to this project and get it back on its feet again...
We do sell the check balls and springs which are currently on e bay or you can PM on either board to save a few bucks.
https://rover.ebay.com/rover/0/0/0?mpre ... 2908144646