Opened it up today , right and center cylinder a bit buggered up.
I dont plan on pulling the bottom end at this point. As for the crank I will look up the side play specs and obviously rotate it to see how smooth it is and pull on the rods to see if they have any play in the big end…pulled on them already and they seem tight...thats all I have ever done and I have seen only one bad crank in my life and it was obvious it was bad ….but is there anything I may need to know or check?
Also I assume I will need new pistons (if two then three for me I guess) I also assume I need to get the bores measured and looked at by someone who can do it correctly (I dont have the tools) to decide what size pistons. Im going to look up Wossner specs hoping to get away with a just a hone but these where wiseco , dont know how much different wossners are.
Any advice anyone has is appreciated! THX
H2 rebuild by
Joe Herriges, on Flickr
H2 rebuild by
Joe Herriges, on Flickr
H2 rebuild by
Joe Herriges, on Flickr
H2 rebuild by
Joe Herriges, on Flickr