I would limit the revs to 7,500 and just swap the sprockets, front to rear.......
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| 70mm stroker crank http://www.kawi2strokes.com/forum/viewtopic.php?f=5&t=9938 |
Page 1 of 1 |
| Author: | kwacka.karl [ Fri Feb 06, 2015 7:59 pm ] |
| Post subject: | 70mm stroker crank |
Well it looks i have built the biggest stroke crank for a h2 in the world not to shabby for a bloke down under .kwacka karl...ozz |
|
| Author: | RODH2 [ Fri Feb 06, 2015 8:07 pm ] |
| Post subject: | Re: 70mm stroker crank |
I would limit the revs to 7,500 and just swap the sprockets, front to rear.......
|
|
| Author: | Jim [ Fri Feb 06, 2015 8:24 pm ] |
| Post subject: | Re: 70mm stroker crank |
Seems to me I read about a guy doing the same thing recently, maybe in the mods-rods section. 
|
|
| Author: | kwacka.karl [ Fri Feb 06, 2015 9:00 pm ] |
| Post subject: | Re: 70mm stroker crank |
Most blokes have only a standard crank to judge off i found about 6 grams difference in some two stroke crank wheels . h2 cranks were made by the thousands and they only had so much time to spend on them that's the difference .kwacka karl ....ozz 
|
|
| Author: | BBP [ Mon Feb 09, 2015 3:41 pm ] |
| Post subject: | Re: 70mm stroker crank |
Thats really cool Karl.....send us some PIC's and good luck with it.......sounds like a serious project  THX Phil 
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|