Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
Best way to bolt drag motor in chassis http://www.kawi2strokes.com/forum/viewtopic.php?f=5&t=4991 |
Page 1 of 1 |
Author: | dencodragbike5608 [ Wed Nov 21, 2012 9:53 pm ] |
Post subject: | Best way to bolt drag motor in chassis |
Ok guys just wandering from the drag racers putting together a denco chassis with a Fast By Gast 130 horse h2 will get pics up of bike when my computer is back up. I,m on my IPad Back to the ? When I put the motor mounts back in I plan on leaving the front motor mount out. And should I tap the cases & bolt it in solid or should I use the stock bolts through thr cases. The Z1 dragbike I had in the mid90's was set up with the cases threaded not sure what is best on a h2 Thanks for the help. |
Author: | nitrouscarl [ Wed Nov 21, 2012 10:08 pm ] |
Post subject: | Re: Best way to bolt drag motor in chassis |
My H2 drag bike back in the day used the stock mounts and ran the best of a 5.68 @ 118 with a 1.26 short time with a fabricated sqaure tube swingarm and a 7" drag slick. |
Author: | Zambia [ Wed Nov 21, 2012 11:03 pm ] |
Post subject: | Re: Best way to bolt drag motor in chassis |
I bought a drag H2 engine and the rear mounts are heli-coiled to accept heavy bolts. It's in my street bike and seems like a good set up. |
Author: | johnatkens [ Thu Nov 22, 2012 8:19 am ] |
Post subject: | Re: Best way to bolt drag motor in chassis |
On my drag motors I installed heli coils on the bottom and rear mounts, did not use the front mounts at all |
Author: | Bill B [ Thu Nov 22, 2012 9:42 am ] |
Post subject: | Re: Best way to bolt drag motor in chassis |
Ditto John |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |