Kawi2strokes.com Forum
http://www.kawi2strokes.com/forum/

Deals Gap 2017 starts now...
http://www.kawi2strokes.com/forum/viewtopic.php?f=35&t=12481
Page 6 of 14

Author:  Tim Steele [ Tue Apr 18, 2017 12:22 am ]
Post subject:  Re: 34 days till Deals Gap 2017

They tried that for the front. A tube is so.much easier...

Author:  Tim Steele [ Thu Apr 20, 2017 8:21 am ]
Post subject:  Re: 31 Days till Deals Gap 2017

31 days Gentlemen.
All the parts for the RZ have arrived. I ordered a gallon of Blue Marble yesterday. I will be gearing up to prep the tractors and hay making equipment soon as we will be making hay the week after I get back. It will all get done. It always does...

Author:  evansje1 [ Fri Apr 21, 2017 8:53 am ]
Post subject:  Re: 30 Days till Deals Gap 2017

Someone may of buggered up the rim sealing surface while prying on a tire, my Daytona has a rim that has a tire tool ding that doesn't like to seal.
I tried to ride my RZ to church Wednesday night. It didn't want to go cause by habit I'd turned the fuel cock to prime thinking I was turning it off. The fuel to air ratio was too much as the float valves seeped a little flooding the engine. When I expect not to be riding my twins I usually pull the fuel lines and plug them with a dowel pin. Then I run the engine a bit to open the float valves so they don't think stick to their seats. I fought a house fire once that was caused by a riding lawn mower's float valve that leaked about a gallon of gas onto the garage floor. The gas flumes got to an ignition source and went off. I noticed after we had knocked down the fire down that the sheet rock had the screw heads popped out. That told me there had been an explosion. I went over to the lawn mower parked there and found the concrete stained under the lawn mower. The owners lost their car in fire and garage contents. Since then I don't trust pet cocks or float valves.
OK I'm done with my safety rant for the day. :D

Author:  Tim Steele [ Sat Apr 22, 2017 10:18 am ]
Post subject:  Re: 29 Days till Deals Gap 2017

I dont know. The front did the same thing and a tube remedied it. I assume it will on the rear as well.
29 Days Gentlemen.

Author:  Tim Steele [ Sun Apr 23, 2017 9:13 am ]
Post subject:  Re: 28 Days till Deals Gap 2017

28 days Gentlemen
You'd best be getting after it...

Author:  Jim [ Sun Apr 23, 2017 9:18 am ]
Post subject:  Re: 28 Days till Deals Gap 2017

I worked on the electrics of the DT100 yesterday. It has new front LED turn signals, repaired rear signals, new LED headlight, electronic flasher, etc.. I want to test it all today, and the headlight needs the engine running, so it'll be a pain with the rain. Life is tough though... DG is more important than staying dry. :D

Author:  Tim Steele [ Mon Apr 24, 2017 9:02 am ]
Post subject:  Re: 27 Days till Deals Gap 2017

Yesterday the Good Doctor Haase and me worked on our riding skills with a brisk run through the beautiful Shenandoah Valley... :thumbup: :thumbup: We flogged the Girly bikes and enhanced community relations :D :D

Author:  Jim [ Mon Apr 24, 2017 9:31 am ]
Post subject:  Re: 27 Days till Deals Gap 2017

I'm glad you guys were able to ride. It rained here pretty much all day, and continues to do that today.

I moved the H2 into the shop so it can get new fork tubes, single EX brake, and new tires.

Author:  m in sc [ Mon Apr 24, 2017 10:23 am ]
Post subject:  Re: 27 Days till Deals Gap 2017

we raised hell around tims ton those roads are fairly epic and it was nice to finally get a LOT of eat time on his rz. aside from the rear tire, his bikes are ready. man that was fun.

:thumbup:

Author:  ThreePipesSmokin [ Mon Apr 24, 2017 10:44 am ]
Post subject:  Re: 27 Days till Deals Gap 2017

m in sc wrote:
we raised hell around tims ton those roads are fairly epic and it was nice to finally get a LOT of eat time on his rz. aside from the rear tire, his bikes are ready. man that was fun.

:thumbup:

Yes, it's fun chasing you around on your RZ...





WHERE'S MY VIDEO!?!? :lol:

Page 6 of 14 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/