Probably not, if it's an H2.
An S3 maybe? Or you meant 71.5mm?
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| H2 center cylinder stock ports 75 plus the trip http://www.kawi2strokes.com/forum/viewtopic.php?f=27&t=6295 |
Page 1 of 1 |
| Author: | sawracer [ Tue Jun 04, 2013 6:54 pm ] |
| Post subject: | H2 center cylinder stock ports 75 plus the trip |
I picked up a spare motor so I don't think I need this anymore. I think bore is 57.5 |
|
| Author: | Jim [ Tue Jun 04, 2013 7:11 pm ] |
| Post subject: | Re: H2 center cylinder stock ports 75 plus the trip |
Probably not, if it's an H2. An S3 maybe? Or you meant 71.5mm?
|
|
| Author: | sawracer [ Tue Jun 04, 2013 11:12 pm ] |
| Post subject: | Re: H2 center cylinder stock ports 75 plus the trip |
I'm sorry, it's 71.5mm. thanks Jim |
|
| Author: | sawracer [ Tue Jun 04, 2013 11:18 pm ] |
| Post subject: | Re: H2 center cylinder stock ports 75 plus the trip |
It's a beautiful baby. 
|
|
| Author: | scrambler73 [ Wed Jun 05, 2013 8:46 am ] |
| Post subject: | Re: H2 center cylinder stock ports 75 plus the trip |
for the record, stock bore is 71mm 71.5 is first over. |
|
| Author: | Hawaii-Mike [ Wed Jun 05, 2013 12:17 pm ] |
| Post subject: | Re: H2 center cylinder stock ports 75 plus the trip |
PM sent |
|
| Author: | sawracer [ Sat Jun 15, 2013 10:20 am ] |
| Post subject: | Re: H2 center cylinder stock ports 75 plus the trip |
Long gone Louie |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|