I made up a few more sets of the Denco style 34mm carb adapter plates for the H1.
These are a little different then the last ones I did but are the same great quality.
The major differences from last time is the round straight tapered hole(like the originals), plain barstock finish, and no included hardware.
With these changes I was able to keep costs down considerably and can pass that on to the community.
A set of 3 adapter plates shipped inside the USA is $50. Add 4% if PayPal is not friends/family and contact me for shipping outside of the US. I will take shipping costs off after the first set if you order more than one set.
I will try to keep checked in here but you can also contact me at jeffabbyisaac@yahoo.com
