Looking for an oil pump end plate.
Looks like this except with the tab intact.
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Need an oil pump end plate. http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=6574 |
Page 1 of 1 |
| Author: | sfront [ Tue Jul 30, 2013 10:38 am ] |
| Post subject: | Need an oil pump end plate. |
Looking for an oil pump end plate. Looks like this except with the tab intact.
|
|
| Author: | Jim [ Tue Jul 30, 2013 12:00 pm ] |
| Post subject: | Re: Need an oil pump end plate. |
Mine broke off the tab. I welded it back on. |
|
| Author: | H2RTuner [ Tue Jul 30, 2013 1:03 pm ] |
| Post subject: | Re: Need an oil pump end plate. |
Just a thought for those persons that are capable of doing so. These parts are simply cold roll sheet steel, and then, spot welded in place, as shown. If a person had fabrication skills, and access to a spot welder, preferably, 220 volt type, they could fix those plates without too much hassle. Most of the oil pumps for early Kawasaki used that same end plate, no matter the number of cylinders, engine sizes. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|