I have a customer that is looking for a set of H2 cylinders that are STD. or on first over. He is in Australia and shipping would be a killer back and forth.
Thanks!
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Hens teeth wanted.......... http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=3705 |
Page 1 of 1 |
| Author: | Ja-Moo [ Fri Jun 29, 2012 2:16 pm ] |
| Post subject: | Hens teeth wanted.......... |
I have a customer that is looking for a set of H2 cylinders that are STD. or on first over. He is in Australia and shipping would be a killer back and forth. Thanks!
|
|
| Author: | RODH2 [ Fri Jun 29, 2012 3:57 pm ] |
| Post subject: | Re: Hens teeth wanted.......... |
Sorry, nothing here. Std or 1st over, hmm, gonna be hard to find! (They all got bored when the rattles set in at 1,000 miles.......!) |
|
| Author: | BarryB [ Fri Jun 29, 2012 8:24 pm ] |
| Post subject: | Re: Hens teeth wanted.......... |
If it ain't ratlin it ain't runnin. |
|
| Author: | AER005 [ Sat Jun 30, 2012 5:24 pm ] |
| Post subject: | Re: Hens teeth wanted.......... |
RODH2 wrote: Sorry, nothing here. Std or 1st over, hmm, gonna be hard to find! (They all got bored when the rattles set in at 1,000 miles.......!) thats exactly what I did in 73 gave it suzuki clearances as they were tighter and it started rattling at 700mls  , so I thrashed the ---- out of it from then on and never worried about rattles again
|
|
| Author: | ZERO [ Sat Jun 30, 2012 9:37 pm ] |
| Post subject: | Re: Hens teeth wanted.......... |
Check THIS out. I've got a brand new top end on my one H2 that was measured and match bored to each piston. It runs great but rattles a lot. My other H2 has a completely shot top end with worn rings,etc. Runs like garbage but is mechanicaly silent! 
|
|
| Author: | husson73 [ Mon Jul 02, 2012 3:29 am ] |
| Post subject: | Re: Hens teeth wanted.......... |
resleeving could be the way 
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|