| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Need low profile intake manifolds for H2 http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=3216 |
Page 1 of 1 |
| Author: | ZERO [ Thu May 03, 2012 4:46 am ] |
| Post subject: | Need low profile intake manifolds for H2 |
I have a reed valve conversion on my 72 H2 (of my own design) and am having difficulty with air cleaner room..The old intakes that I had, had dry rotted and I replaced them with new ones, but the new design is 3/8" deeper and now the carbs sit back too far. (I have 34mm Mikuni round pumpers.) Is anyone aware of shallow intakes like the old type? |
|
| Author: | III [ Thu May 03, 2012 6:03 am ] |
| Post subject: | Re: Need low profile intake manifolds for H2 |
http://cgi.ebay.com/ebaymotors/ws/eBayI ... 1558.l2649 H2B intakes any good? |
|
| Author: | soflah2b [ Thu May 03, 2012 8:54 am ] |
| Post subject: | Re: Need low profile intake manifolds for H2 |
They are still an active part number from Kawasaki, pricey but new. |
|
| Author: | ZERO [ Thu May 03, 2012 10:34 am ] |
| Post subject: | Re: Need low profile intake manifolds for H2 |
I've got the larger diameter 34mm carbs. I don't think that the originals will work. Will they? I'll measure the O.D diameter of the carbs.. Thank you. |
|
| Author: | mraxl [ Thu May 03, 2012 10:47 am ] |
| Post subject: | Re: Need low profile intake manifolds for H2 |
My understanding is that the OE will fit but not without effort. That is not from personal experience... |
|
| Author: | soflah2b [ Thu May 03, 2012 10:57 am ] |
| Post subject: | Re: Need low profile intake manifolds for H2 |
They will fit. I have TM34 with stock boots. You want to wet the inside of the boot and they will slip in. |
|
| Author: | ZERO [ Fri May 04, 2012 3:41 am ] |
| Post subject: | Re: Need low profile intake manifolds for H2 |
Thank you |
|
| Author: | jcsnook [ Sun May 06, 2012 9:21 am ] |
| Post subject: | Re: Need low profile intake manifolds for H2 |
Shouldn't you be able to order something suitable from SUDCO? |
|
| Author: | ZERO [ Sun May 06, 2012 2:39 pm ] |
| Post subject: | Re: Need low profile intake manifolds for H2 |
I bought my new ones from SUDCO. They're not the exact same dimentions and in my application, that tiny difference matters. (depth).They are very well made and very plyable. I'll use them on another build. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|