Kawi2strokes.com Forum
http://www.kawi2strokes.com/forum/

S2A points cam
http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=1631		 Page 1 of 2
Author:  Leemata [ Fri Nov 18, 2011 6:53 pm ]
Post subject:  S2A points cam
Looking for a points cam for a '73 S2A. The pin on mine has been snapped off. Check it out:

Terry

Image
Author:  Jackman [ Fri Nov 18, 2011 10:31 pm ]
Post subject:  Re: S2A points cam
Ive got a 72 S2 points cam, that should be the same :idea:
Author:  Leemata [ Sat Nov 19, 2011 8:41 am ]
Post subject:  Re: S2A points cam
Just checked and the P/N are the same. What do you want for it?

Terry
Author:  Jackman [ Sat Nov 19, 2011 10:53 am ]
Post subject:  Re: S2A points cam
pm sent
Author:  Leemata [ Thu Nov 24, 2011 9:06 am ]
Post subject:  Re: S2A points cam
I'm still looking for a points cam for an S2A. Member "Jackman" was kind enough to work one loose off of his parts bike, but it's a bit rusty.

Anyone else have a decent one?

Thanks again Jack!

Terry
Author:  Jackman [ Thu Nov 24, 2011 10:38 am ]
Post subject:  Re: S2A points cam
Terry I scrub the cam a little more and attempted a close up shot it looks better than it did :o , the area above the cam lobe has the most pitting but is that area a function part.

Could this be a usable part?


Image
Author:  Jackman [ Thu Nov 24, 2011 10:44 am ]
Post subject:  Re: S2A points cam
Image
Author:  n2trips [ Fri Nov 25, 2011 9:18 am ]
Post subject:  Re: S2A points cam
pm sent
Author:  Jackman [ Fri Nov 25, 2011 9:44 am ]
Post subject:  Re: S2A points cam
Confirmed my S2 points cam in previous pic when compared to the same part in my S3 its toast, contact area above the cam lobe is all pitted bad cam it self also pitted.
Author:  mraxl [ Fri Nov 25, 2011 1:11 pm ]
Post subject:  Re: S2A points cam
You can put JB Weld in those pits and polish it out to be like new.
You can also drill out the broken locating pin and replace it.
Page 1 of 2 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/