Looking for a Signal Coil to get my 1969 H1 running.
Thanks
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Signal Generator Coil for 1969 H1 http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=14594 |
Page 1 of 1 |
| Author: | Simmons1 [ Sat Nov 27, 2021 9:41 pm ] |
| Post subject: | Signal Generator Coil for 1969 H1 |
Looking for a Signal Coil to get my 1969 H1 running. Thanks
|
|
| Author: | H2RTuner [ Tue Nov 30, 2021 2:12 pm ] |
| Post subject: | Re: Signal Generator Coil for 1969 H1 |
Make sure you use one that specs out at stock values. Different resistance values can alter timing curves in the CDI box. Jim should be able to either build one, or, find a suitable replacement. |
|
| Author: | Simmons1 [ Wed Dec 01, 2021 5:41 pm ] |
| Post subject: | Re: Signal Generator Coil for 1969 H1 |
I bought Jim's CDI but I don't think he has any Signal Coils. I have got a used one coming that reads 305 ohms. I am hoping that's close enough to the 350 the manual calls for. |
|
| Author: | H2RTuner [ Fri Dec 03, 2021 2:17 pm ] |
| Post subject: | Re: Signal Generator Coil for 1969 H1 |
When you proceed to set the pickup gap, use a brass feeler gauge, not a steel one. |
|
| Author: | Pecka [ Sat Dec 04, 2021 7:07 am ] |
| Post subject: | Re: Signal Generator Coil for 1969 H1 |
H2RTuner wrote: When you proceed to set the pickup gap, use a brass feeler gauge, not a steel one. What's the difference? |
|
| Author: | H2RTuner [ Sat Dec 04, 2021 7:39 pm ] |
| Post subject: | Re: Signal Generator Coil for 1969 H1 |
Direct magnetic transfer vs no magnetin transfer |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|