Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
H2 crank collar spacer http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=13219 |
Page 1 of 1 |
Author: | h2racer [ Sun Dec 17, 2017 10:56 pm ] |
Post subject: | H2 crank collar spacer |
This is the part that goes behind the crank gear on a H2, part number 92027-133. $50 on ebay is too much! If you need H1/H2 parts in the SF bay area let me know. Thanks Dave |
Author: | JRD [ Tue Dec 19, 2017 8:21 pm ] |
Post subject: | Re: H2 crank collar spacer |
Anyone have the dimensions of this spacer? That would be easy to make on the lathe for a LOT cheaper. Jeff |
Author: | H2RTuner [ Wed Dec 20, 2017 3:43 am ] |
Post subject: | Re: H2 crank collar spacer |
If you make one from scratch, it should also be hardened to at least seal race specification. It might so need to be even harder because it is also a distance collar as well, held tight with/agaInst a torque specification. |
Author: | R.B. [ Wed Dec 20, 2017 9:26 am ] |
Post subject: | Re: H2 crank collar spacer |
Aftermarket Ones have been available for a few Years now - around $22 |
Author: | porschedave [ Wed Dec 20, 2017 9:31 am ] |
Post subject: | Re: H2 crank collar spacer |
Hey Dave C I got you . I have new ones that I buy for all the money too. But I have a good used one you can have . Yes Jeff lets do it . Right now there Isn't any collar sets I know of on the market. H2 is tough in them more so than H1. |
Author: | h2racer [ Thu Dec 21, 2017 11:39 am ] |
Post subject: | Re: H2 crank collar spacer |
Thanks Dave, a used one is fine! Are you in Pleasanton at all over the next week, or could I come over? If you need any triple bits you are welcome to have a rummage. Dave |
Author: | porschedave [ Fri Dec 22, 2017 10:07 pm ] |
Post subject: | Re: H2 crank collar spacer |
I hope you found the collar in the H2 tank mailbox Dave I dropped it by early today |
Author: | h2racer [ Sat Dec 23, 2017 11:53 am ] |
Post subject: | Re: H2 crank collar spacer |
Thank you Dave, just what I asked Santa for! Have a great one. Dave |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |