| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| KH400 stator with exciter coils still intact http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=13205 |
Page 1 of 2 |
| Author: | 400500750 [ Mon Dec 11, 2017 4:59 pm ] |
| Post subject: | KH400 stator with exciter coils still intact |
Does NOT have to run. "Non-electrical, slow-working caveman"(me) took low and hi spd coils out to put in new (Jim's replacement); taking phone pics; but angles, room light, and passage of time baffles me. (Jim has tried extra instructions). Willing to buy complete, dirty, stator assembly just to have it as model - as I try to solder all back. Best if even the ground(s) are still attached. thx in advance. 
|
|
| Author: | Jim [ Mon Dec 11, 2017 5:13 pm ] |
| Post subject: | Re: KH400 stator with exciter coils still intact |
Maybe someone with an original stator that's not installed in an engine could post a good photo of the two coils stacked up so you can see the wires. |
|
| Author: | 400500750 [ Tue Dec 12, 2017 1:32 pm ] |
| Post subject: | Re: KH400 stator with exciter coils still intact |
thx Jim; and if no reply to that suggestion, I saw what is labeled as a KH400 site I may should try. |
|
| Author: | mraxl [ Tue Dec 12, 2017 5:35 pm ] |
| Post subject: | Re: KH400 stator with exciter coils still intact |
Does this show what you want? http://kawatriple.com/kh400a5/0643.jpg |
|
| Author: | III [ Tue Dec 12, 2017 6:26 pm ] |
| Post subject: | Re: KH400 stator with exciter coils still intact |
I hope these help. Actually some of Jims earlier coils, newer ones are much prettier ! ! !  Attachment: kh400statorcoilsB.jpg Attachment: kh400statorcoilsA.jpg
|
|
| Author: | 400500750 [ Wed Dec 13, 2017 1:46 pm ] |
| Post subject: | Re: KH400 stator with exciter coils still intact |
THX "III"; I am as weak on 'computers' as on 'electrical knowledge'. I think I hit "new post" by accident.....can you look for the "thx for the Zoom" topic for my follow up question. HUGE seasonal thanks!! |
|
| Author: | 400500750 [ Thu Dec 14, 2017 1:48 pm ] |
| Post subject: | thx for replies and (big) pics |
Thx, Dale, Jim and III. I may can finish soldering Sunday, as weather should be warm. Hopefully if I misplace 1 connect, it just 'won't start'. Gracias! |
|
| Author: | mraxl [ Thu Dec 14, 2017 2:01 pm ] |
| Post subject: | Re: KH400 stator with exciter coils still intact |
Here is a wiring diagram if it helps: http://kawatriple.com/cdi400.jpg |
|
| Author: | 400500750 [ Fri Dec 15, 2017 2:14 pm ] |
| Post subject: | Re: KH400 stator with exciter coils still intact |
I had first looked at a wiring diagram, but it doesn't 'separate' the exciter coils graphically. It appears to indicate a red goes to upper terminal of each, and a white goes to the lower terminal of each, which seems logical even to me. I will combine this w. diagram's (hints) with other collected responses and paperwork spread out on my garage floor soon and finalize my soldering. Have a safe weekend y'all ! |
|
| Author: | Jim [ Fri Dec 15, 2017 2:33 pm ] |
| Post subject: | Re: KH400 stator with exciter coils still intact |
As you can see in III's photo: * on the upper coil, which is the high speed coil, a white wire goes from the right terminal to the LS coil's left terminal. * The harness' white wire also connects to the LS coil's left terminal * The harness' red wire connects to the HS coil's (upper coil's) left terminal. * The harness' black wire connects to the mounting screw (ground) * Another black wire connects to that same screw, and to the LS coil's right terminal. This agrees with the wiring diagram that Mraxl posted. |
|
| Page 1 of 2 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|
