| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| '72 H2 engine bolt set... http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=13163 |
Page 2 of 2 |
| Author: | H1FR [ Tue Nov 14, 2017 11:56 pm ] |
| Post subject: | Re: '72 H2 engine bolt set... |
pmcburney wrote: Thanks for the replies and advice! I'll likely go with the Patrick Bras kit, although the 10mm 'bolts' in that kit have a nut at each end... Are the OEM bolts, bolts (with a head as such) or are they essentially a rod with a threaded section on each end like the Patrick Bras kit? His kit is more like a early H1 design. Mosty all wrong for a H2, except for 2 short bolts. The 8mm bolts are the only pieces you can't find new or restored easily on eBay. |
|
| Author: | pmcburney [ Wed Nov 15, 2017 12:39 am ] |
| Post subject: | Re: '72 H2 engine bolt set... |
Ah, ok. I can fairly easily source the 8mm bolts here, as that's not an altogether unusual size - the long 10mm ones don't exist anywhere but in Kawasaki's parts catalogue or an engineering shop... All I really need is one of the 10mm x 274mm bolts, the two 8mm x 125mm bolts and some washers and nuts to suit both bolt sizes. So... if anyone has one of the 10mm jobbies? |
|
| Author: | RODH2 [ Wed Nov 15, 2017 6:49 am ] |
| Post subject: | Re: '72 H2 engine bolt set... |
...Let me check what I have, I went through this a few (Well, like 20 years ago!), and have some agro 10mm bolts left over. I picked the best ones for my eternal project, but I'm sure I have some bolts that will do the job....they will need a wire wheel, and re-zincing, but I have them! Plus, I'm in Australia......give me a day or so , and I will check. They are yours, if I can find them!  
|
|
| Author: | H1FR [ Wed Nov 15, 2017 11:38 am ] |
| Post subject: | Re: '72 H2 engine bolt set... |
I have everything except for the 8mm bolts. All re-zinc coated. In USA |
|
| Author: | pmcburney [ Wed Nov 15, 2017 7:08 pm ] |
| Post subject: | Re: '72 H2 engine bolt set... |
RODH2 wrote: ...Let me check what I have, I went through this a few (Well, like 20 years ago!), and have some agro 10mm bolts left over. I picked the best ones for my eternal project, but I'm sure I have some bolts that will do the job....they will need a wire wheel, and re-zincing, but I have them! Plus, I'm in Australia......give me a day or so , and I will check. They are yours, if I can find them! Hey, thanks Rod! I'll take one of the 10mm x 274mm bolts off your hands! |
|
| Author: | RODH2 [ Mon Nov 20, 2017 5:28 am ] |
| Post subject: | Re: '72 H2 engine bolt set... |
P.M. me your address, and I'll send 1 your way, it will need a re-zinc! Just 1 10X270mm bolt needed?
|
|
| Page 2 of 2 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|