I can't tell you anything more than what I have read. So maybe Googling them both might give you more insight.
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Tomcat h2 pipes http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=12107 |
Page 1 of 3 |
| Author: | 4cyl h2 [ Wed Sep 14, 2016 8:55 pm ] |
| Post subject: | Tomcat h2 pipes |
Haven't been around in a long time. Are these still being made anybody got a set for sale give me a call618-407-8810 or an email dwbrown58@gmail.com |
|
| Author: | Ja-Moo [ Wed Sep 14, 2016 9:47 pm ] |
| Post subject: | Re: Tomcat h2 pipes |
Not for a long time. Lots of good pipes out now though. |
|
| Author: | 4cyl h2 [ Wed Sep 14, 2016 10:22 pm ] |
| Post subject: | Re: Tomcat h2 pipes |
Was another member making them What happened. What are some of the other good pipes |
|
| Author: | Ja-Moo [ Wed Sep 14, 2016 11:59 pm ] |
| Post subject: | Re: Tomcat h2 pipes |
never panned out. There are Denco copies from Jim here soon, Lomas, GAT, K2tec, jolymotos, WTF cone kits, and a few more. |
|
| Author: | 4cyl h2 [ Thu Sep 15, 2016 8:25 am ] |
| Post subject: | Re: Tomcat h2 pipes |
What's the deal on the cone kits and which of the ones you listed are most like toms |
|
| Author: | Ja-Moo [ Thu Sep 15, 2016 8:45 am ] |
| Post subject: | Re: Tomcat h2 pipes |
The WTF's are from Andrew on the board, board name Walms. Look under the vendor section here for more info. Tom's pipes were a bit over-rated. And it depends on where you want your power, high or low rpm. |
|
| Author: | 4cyl h2 [ Sun Sep 18, 2016 8:44 am ] |
| Post subject: | Re: Tomcat h2 pipes |
Thanks for the lead. Will be looking into something approiate I've always used mostly standard Gast and a set of Denco pipes Heard there's been a lot of improvement since then |
|
| Author: | Ja-Moo [ Sun Sep 18, 2016 8:52 am ] |
| Post subject: | Re: Tomcat h2 pipes |
The Jolly Motos seem to be good modern pipes, as do the Jim Lomas pipes. I suppose you are looking for more of a top end pipe? |
|
| Author: | 4cyl h2 [ Sun Sep 18, 2016 12:40 pm ] |
| Post subject: | Re: Tomcat h2 pipes |
Can you describe the basics of each. I haven't decided what would be best yet it will depend on porting But will prob be at least a 38 mm carb |
|
| Author: | Ja-Moo [ Sun Sep 18, 2016 12:47 pm ] |
| Post subject: | Re: Tomcat h2 pipes |
I can't tell you anything more than what I have read. So maybe Googling them both might give you more insight.
|
|
| Page 1 of 3 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|