Ive used a chain link, bent in center aprox. 45deg. weld to attach it in the center hole, does the trick...
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| chamber spring tabs http://www.kawi2strokes.com/forum/viewtopic.php?f=26&t=10410 |
Page 1 of 1 |
| Author: | two-stroke-brit [ Fri May 01, 2015 11:28 am ] |
| Post subject: | chamber spring tabs |
The tabs that go under the spigot bolts to attach the springs to. anyone know where to get these in the US . norbo on the RDLCCRAZY site has them but would be quicker for me if i can locate some stateside. T I A Mark |
|
| Author: | Zambia [ Fri May 01, 2015 12:37 pm ] |
| Post subject: | Re: chamber spring tabs |
I've seen everything from wire to washers welded on - didn't know there was an actual "thing"... |
|
| Author: | paulh [ Fri May 01, 2015 3:41 pm ] |
| Post subject: | Re: chamber spring tabs |
Ive used a chain link, bent in center aprox. 45deg. weld to attach it in the center hole, does the trick...
|
|
| Author: | two-stroke-brit [ Fri May 01, 2015 4:11 pm ] |
| Post subject: | Re: chamber spring tabs |
there is not much to them for sure . i like the tabs because it spreads the load more evenly the further apart the mounts are. if i cant find some i guess i will make them out of some thin sheet. just too lazy unless pushed to do it.  thanks all.mark |
|
| Author: | JRD [ Sat May 02, 2015 6:14 am ] |
| Post subject: | Re: chamber spring tabs |
You want sheetmetal tabs ( wirges style ) or bent wire ( Denco style ) ? I had a piece of sheetmetal bent up for the wirges style but it seems everybody wanted the Denco style instead. Jeff |
|
| Author: | two-stroke-brit [ Sun May 03, 2015 11:17 am ] |
| Post subject: | Re: chamber spring tabs |
thanks jeff , i am mid bodge as i type. cheers mark |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|