Kawi2strokes.com Forum

After a recent search, I couldn't locate either an NOS original, good used, or model-specific aftermarket sprocket with the original spec 43 teeth. I recall that a few others in recent past had also had a difficult time locating this as well. I also did not feel like changing over to a 520 at this point, so the search continued and I came up with this:

http://www.z1enterprises.com/ItemDetails.aspx?itemDescription=530+%28JTR476+series%29+43T+Rr+Sprocket&item=BAJTR476-43

After looking at the dimensional specs, I decided to take a chance and ordered two of the same PN. As you will see I received two sprockets but from different manufacturers. The differences between my worn oem and these two appear to be minimal, and I think either will work fine as far as keeping aligned with the front sprocket...? At just under $31 + s&h, these appear to be a good less expensive alternative to costly NOS.








I just noticed this on their website , so contact them ahead of time before placing an order for these sprockets.


I also picked up 3 of the jet needle "e" clips, as well as 4 repro S2/H2/H1B signal lenses at relatively inexpensive prices.

_________________
"Only cheat the cheaters, boy - you can't cheat an honest man!" Mordecai Jones - The Flim Flam Man.