Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
Bead Blasting by the Job, Parts Cleaning by the Hour http://www.kawi2strokes.com/forum/viewtopic.php?f=25&t=49 |
Page 5 of 7 |
Author: | Tim Steele [ Thu Sep 22, 2011 4:35 pm ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
Repair done and about 2 more hours of case sanding and smoothing. After welding At Doug Bell's Repair partially blended. Ready to go back in the blast cabinet. |
Author: | JoeMcdonald [ Thu Sep 22, 2011 11:05 pm ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
Now thats really nice! |
Author: | Iron [ Fri Sep 23, 2011 9:39 am ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
Good job Tim. Thats the thing with restore one never knows what he is going to find. Comming out good tho. later. |
Author: | Tim Steele [ Fri Sep 23, 2011 1:50 pm ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
I was hoping to finish it today, but it is pouring rain so the humidity is too high to bead blast. I am hoping to get on it again tomorrow evening after the Steele family reunion, weather permitting. I have about 4 hours of work left to do, both halves through the cabinet at 40 PSI to knock the shine off, then rechase all the threads, box her up, and Bob's your Uncle... |
Author: | Tim Steele [ Tue Sep 27, 2011 9:02 pm ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
More progress: Inner bottom case: Bottom case rear: Bottom case done! |
Author: | Jim [ Tue Sep 27, 2011 10:30 pm ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
Tim, as simple as this thread is, it's fun to see the progress. That aluminum is starting to look too good to be real! |
Author: | Tim Steele [ Wed Sep 28, 2011 4:44 pm ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
Thanks Jim, The weather has been most of the limiting factor on this one. Even with 2 inline water filters if it is too humid the glass beads just ball up and won't go through the nozzle... |
Author: | Tim Steele [ Sat Oct 01, 2011 9:31 pm ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
Joe Mcdonald's H2 motor, All threads chased ready for Joe!!! Front: LH View: RH view: And bringing up the rear: All that's left is boxing it up |
Author: | Iron [ Sun Oct 02, 2011 8:19 am ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
Dammmmm Tim, nice. All you need now is the T-shirt. |
Author: | Tim Steele [ Sun Oct 02, 2011 6:56 pm ] |
Post subject: | Re: Bead Blasting by the Job, Parts Cleaning by the Hour |
Thanks Ol Podnah... |
Page 5 of 7 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |