here is a Samurai with a few avenger parts on it that i bought from another board member a back in January had new tank pads copied from old ones, fresh paint and a good clean up.
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| 1968 Samurai http://www.kawi2strokes.com/forum/viewtopic.php?f=22&t=6157 |
Page 1 of 1 |
| Author: | dwayneh [ Wed May 15, 2013 2:49 pm ] |
| Post subject: | 1968 Samurai |
here is a Samurai with a few avenger parts on it that i bought from another board member a back in January had new tank pads copied from old ones, fresh paint and a good clean up.
|
|
| Author: | two-stroke-brit [ Wed May 15, 2013 4:35 pm ] |
| Post subject: | Re: 1968 Samurai |
Thanks an eclectic colection you have there  and how many post boxes does one man need 
|
|
| Author: | strokerface [ Wed May 15, 2013 7:07 pm ] |
| Post subject: | Re: 1968 Samurai |
Very cool! 
|
|
| Author: | suthernS2 [ Wed May 15, 2013 7:10 pm ] |
| Post subject: | Re: 1968 Samurai |
Looking good, how does it run? |
|
| Author: | Jim [ Wed May 15, 2013 7:29 pm ] |
| Post subject: | Re: 1968 Samurai |
Excellent, dwayneh, Really beautiful color. A pair of chambers and clubmans and I'd ride it. 
|
|
| Author: | Ric [ Wed May 15, 2013 7:35 pm ] |
| Post subject: | Re: 1968 Samurai |
Very nice Samurai.....nice root beer too...... |
|
| Author: | dwayneh [ Wed May 15, 2013 8:23 pm ] |
| Post subject: | Re: 1968 Samurai |
Hey Suthern! runs bitchin good ,next day after i bought it put a new battery in it and removed carbs and they were looked great.. fresh gas and she cranked up in about 6 kicks, she fired up.. set of points later and thats about all motor work it needed, spent some money on appearance , but motor and trans were tight, clutch was froze and was able to break it loose but clutch is still weak |
|
| Author: | III [ Thu May 16, 2013 1:46 am ] |
| Post subject: | Re: 1968 Samurai |
Picking this one up this weekend and I could only hope it comes out as nice as yours.  Needs pistons but I will likely have the crank done too. |
|
| Author: | dwayneh [ Thu May 16, 2013 12:39 pm ] |
| Post subject: | Re: 1968 Samurai |
III, thats a really nice piece to start out with, i have a friend in indiana thats has tons of GOOD parts for these i can hook ya up with if ya need any, once again thats a nice start, i did put mine on charlotte craigslist , put a ridiculous price though, gotta start somewhere |
|
| Author: | Charcoal [ Sat May 18, 2013 5:40 pm ] |
| Post subject: | Re: 1968 Samurai |
Nice bike!! Salami slicer motors are so darn cool. I gather that those motors respond very well to a good set of chambers. Good luck!
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|