Kawi2strokes.com Forum
http://www.kawi2strokes.com/forum/

My h2 with Higgsy stainles pipes
http://www.kawi2strokes.com/forum/viewtopic.php?f=22&t=3352
Page 1 of 6

Author:  magee [ Sun May 20, 2012 4:11 pm ]
Post subject:  My h2 with Higgsy stainles pipes

Image
Image

still have to mount the right hand pipes yet.

Author:  oxford [ Sun May 20, 2012 4:14 pm ]
Post subject:  Re: My h2 with Higgsy stainles pipes

:thumbup:

Author:  III [ Sun May 20, 2012 4:29 pm ]
Post subject:  Re: My h2 with Higgsy stainles pipes

well Henry, they say ya cant hurry progress or success.
Looks like you hit both those marks man.
Had it out to get it dirty yet?
Looks like one hell of a ride.
:thumbup: :thumbup: :thumbup:

Author:  Ja-Moo [ Sun May 20, 2012 5:23 pm ]
Post subject:  Re: My h2 with Higgsy stainles pipes

I would suggest you rubber mount the rear mounts. Aa SS cracks
easier than mild steel.

Author:  magee [ Sun May 20, 2012 5:46 pm ]
Post subject:  Re: My h2 with Higgsy stainles pipes

Ja-Moo wrote:
I would suggest you rubber mount the rear mounts. Aa SS cracks
easier than mild steel.


put your glasses on, the hole in the pipes bracket has a rubber grommet in it. I have used a shoulder bolt as not to compress it to much. The pipe has some wiggle in it.

Author:  Ja-Moo [ Sun May 20, 2012 6:41 pm ]
Post subject:  Re: My h2 with Higgsy stainles pipes

From the pic you can't tell, glasses or not...... But good!

Author:  ZERO [ Mon May 21, 2012 4:07 am ]
Post subject:  Re: My h2 with Higgsy stainles pipes

Is that a standard length Airtech seat (Hansen) or have you lengthened it? The fit looks great!

Author:  R.B. [ Mon May 21, 2012 4:21 am ]
Post subject:  Re: My h2 with Higgsy stainles pipes

It'll run a WHOLE lot better with the centre plug cap on H ;) . . . NICE Job - When do I get a go ? . . . . Oh, what condition is the throttle cable in :roll:

Author:  magee [ Mon May 21, 2012 2:42 pm ]
Post subject:  Re: My h2 with Higgsy stainles pipes

R.B. wrote:
It'll run a WHOLE lot better with the centre plug cap on H ;) . . . NICE Job - When do I get a go ? . . . . Oh, what condition is the throttle cable in :roll:


stop by any time just bring a newspaper for the wife. the throttle cable is fine, you wont be pulling it that hard as the bikes too fast for you.

Author:  kas750 [ Mon May 21, 2012 4:11 pm ]
Post subject:  Re: My h2 with Higgsy stainles pipes

That looks a great Job Henry,well done...If i could give some constructive criticism,i am not a big fan of the headlamp arrangement.
A round headlamp would make a world of difference.

Page 1 of 6 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/