| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| I quit... http://www.kawi2strokes.com/forum/viewtopic.php?f=21&t=4438 |
Page 1 of 1 |
| Author: | Bugman Jeff [ Mon Sep 17, 2012 9:03 pm ] |
| Post subject: | I quit... |
That's it. I'm done. I quit. I put in my two weeks today. Two weeks from now, I'll no longer be an employee of Regal Roadsters ( http://www.regalroadsters.com ) I quit my job to start my career. I'll be starting as a CNC setup tech with the intent to advance to a CNC programmer 
|
|
| Author: | 67lotus49 [ Mon Sep 17, 2012 9:13 pm ] |
| Post subject: | Re: I quit... |
Good for you Jeff. I quite doing bodywork after 32 years in June myself. |
|
| Author: | kx85 [ Mon Sep 17, 2012 9:26 pm ] |
| Post subject: | Re: I quit... |
Wishing you the very best in your new endevours! 
|
|
| Author: | BarryB [ Mon Sep 17, 2012 10:10 pm ] |
| Post subject: | Re: I quit... |
Change is almost ALWAYS good. Luck - no - POSITIVE vibes your way
|
|
| Author: | Jim [ Mon Sep 17, 2012 10:40 pm ] |
| Post subject: | Re: I quit... |
Jeff, with the bodywork skills you showed us, I'm sure you'll do fine in the CNC world. |
|
| Author: | Ja-Moo [ Tue Sep 18, 2012 12:51 am ] |
| Post subject: | Re: I quit... |
Go get em! |
|
| Author: | Bugman Jeff [ Tue Sep 18, 2012 7:18 pm ] |
| Post subject: | Re: I quit... |
Thanks all I was a bit under employed there, all things concidered. On top of being an ASE certified tech, I'm a certified Tech Ed teacher, and nearly have a Masters degree in Management. It was a good job, no question about that, but there wasn't enough thinking involved, and not much problem solving. That's the problem with restoring cars, it's a lot of paint by number  It wasn't going anywhere either. The company is small, the only person above me is the owner so there was no room for advancement. With the new job, I fully intend to be the Director of Manufacturing by the time I retire
|
|
| Author: | two-stroke-brit [ Tue Sep 18, 2012 9:39 pm ] |
| Post subject: | Re: I quit... |
Bugman Jeff wrote: That's it. I'm done. I quit. I put in my two weeks today. Two weeks from now, I'll no longer be an employee of Regal Roadsters ( http://www.regalroadsters.com ) I quit my job to start my career. I'll be starting as a CNC setup tech with the intent to advance to a CNC programmer mastercam is a good programing system , a one day course was all i needed to bodge my way through the lathe side, and i think the milling is 3 to 5 days . plenty of work for a good programer here in houston if you fancy a change of scene. good luck mark |
|
| Author: | husson73 [ Wed Sep 19, 2012 3:14 am ] |
| Post subject: | Re: I quit... |
All my best on your new career 
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|