Kawi2strokes.com Forum

I have 3 transmissions to do so all the bearings including the needle bearings. l was also was going to get ball bearing pushers. Any other source? I can get the open roller bearings from VBX but not sure where to get the needle bearings. Could use a good source for the 24mm circlips also. Have been getting them from
Partszilla but they usually have to order them and not in stock most of the time. I don't like re-using circlips. Need to order some clutch releases from Ralf
again also.

Call FBG. I've bought the ball bearing pushers from them in the past. They might have the rest you need.

I know that the bearings can be resourced and may be worth a look at the resource site.
FBG would also be a good source.
Oddly enough, I was going to buy a set of H2 transmission bearings and clips but found out the R&D can supply those parts on a set-up.
At worst Mark could sell them to you.

_________________
There are only two types of motor sport racing:
Nitro and everything else
(Sometimes referred to as fast and slow)