| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| VJMC meeting http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=6476 |
Page 1 of 2 |
| Author: | Moriniman [ Sat Jul 13, 2013 5:37 am ] |
| Post subject: | VJMC meeting |
I rode my H1A to a VJMC meeting at Classic Bikes Direct in Braeside, Melbourne. I was chatting to a guy about his H1A project, and it turns out he lives in the suburb next to me. I also chatted to the Japanese owner of the Honda 400/4 (I have a 350/4). As soon as he pulled up I could tell his tappets were incorrectly set. All-in-all, a good day (free coffee & sausages)! Trevor 
|
|
| Author: | R.B. [ Sat Jul 13, 2013 6:34 am ] |
| Post subject: | Re: VJMC meeting |
I see we have horn "issues" in Australia as well 
|
|
| Author: | Ja-Moo [ Sat Jul 13, 2013 9:51 am ] |
| Post subject: | Re: VJMC meeting |
R.B. wrote: I see we have horn "issues" in Australia as well Australia "is" upside down, so it is correct........ 
|
|
| Author: | nitrouscarl [ Sat Jul 13, 2013 10:05 am ] |
| Post subject: | Re: VJMC meeting |
Ja-Moo wrote: R.B. wrote: I see we have horn "issues" in Australia as well Australia "is" upside down, so it is correct........ Good point John  
|
|
| Author: | R.B. [ Sat Jul 13, 2013 11:55 am ] |
| Post subject: | Re: VJMC meeting |
But it's NOT upside down . . . . . It's inside out!
|
|
| Author: | nitrouscarl [ Sat Jul 13, 2013 12:33 pm ] |
| Post subject: | Re: VJMC meeting |
Ok Ok I am taking notes (incase I put a horn on one of my bikes)
|
|
| Author: | III [ Sat Jul 13, 2013 2:33 pm ] |
| Post subject: | Re: VJMC meeting |
nitrouscarl wrote: Ok Ok I am taking notes (incase I put a horn on one of my bikes) Best take note, if you dont mount it with the "correct" washers and hex nuts, HE will see it. 
|
|
| Author: | MikeH1A [ Sun Jul 14, 2013 3:55 am ] |
| Post subject: | Re: VJMC meeting |
But he gets extra points very a tastily polished front guard, so we should let him off (as long as he promises to rectify it of course  ) Lovely looking bike, you have done well with it.
|
|
| Author: | rusty34 [ Sun Jul 14, 2013 10:45 am ] |
| Post subject: | Re: VJMC meeting |
My horn is just like that one!  Everyone should post their Kawi's picture here so they can find out from RB what 50 or 60 things needs to be corrected!
|
|
| Author: | R.B. [ Sun Jul 14, 2013 10:52 am ] |
| Post subject: | Re: VJMC meeting |
rusty34 wrote: My horn is just like that one! . It IS the correct horn  however, it is mounted outside the frame rather than on the innerside of the downtubes like all '69 - '71's should be 
|
|
| Page 1 of 2 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|