| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Strange issue with clutch rod ball bearing http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=14925 |
Page 1 of 1 |
| Author: | Hawaii-Mike [ Wed Oct 11, 2023 8:55 pm ] |
| Post subject: | Strange issue with clutch rod ball bearing |
I took my H2 motor apart, carefully bagging up everything. When I put it back together, the ball bearing that fits in with the clutch pushrods and mushroom would not go into the shaft! When I put the bearing in on the clutch side, the mushroom would not go all the way in. I don't get it, these are all the same parts. The rods and mushroom fit just fine. The ball bearing size is 5/16". I went to the hardware store and picked up a 1/4" ball bearing - that worked. Any ideas why the same ball bearing would not go into the shaft? |
|
| Author: | Jim [ Wed Oct 11, 2023 9:45 pm ] |
| Post subject: | Re: Strange issue with clutch rod ball bearing |
At first I thought you were talking about a clutch release with a ball bearing at the pusher like the one below, but it looks like you mean the single steel ball between the actuator and the mushroom. Yes, mine is definitely 5/16". Could there be some hardened oil or a burr, or something like that in the bore? |
|
| Author: | ALTERED IMAGE [ Wed Oct 11, 2023 11:34 pm ] |
| Post subject: | Re: Strange issue with clutch rod ball bearing |
Moisture swelled it! |
|
| Author: | Hawaii-Mike [ Thu Oct 12, 2023 5:18 pm ] |
| Post subject: | Re: Strange issue with clutch rod ball bearing |
Hi Jim, Yes I am referring to the single 5/16" ball bearing. I have the engine back together and I think the 1/16" difference with the smaller bearing won't make a difference. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|