| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Before or after boring? http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=14696 |
Page 1 of 1 |
| Author: | Hillclimber [ Sun Jun 12, 2022 8:49 pm ] |
| Post subject: | Before or after boring? |
Should the cylinders on an H1 be bored out to new size before or after bead blasting? |
|
| Author: | Tim Steele [ Sun Jun 12, 2022 8:54 pm ] |
| Post subject: | Re: Before or after boring? |
My customers preference has historically been before. |
|
| Author: | ALTERED IMAGE [ Mon Jun 13, 2022 4:39 am ] |
| Post subject: | Re: Before or after boring? |
Just wondering why bead blast after bore/hone? I see no logic. cliff |
|
| Author: | H2RTuner [ Mon Jun 13, 2022 9:27 am ] |
| Post subject: | Re: Before or after boring? |
LAST operations are bore/hone First, clean, bead blast, close pores in the aluminum with Brillo pad. |
|
| Author: | Yeddy911 [ Mon Jun 13, 2022 10:25 am ] |
| Post subject: | Re: Before or after boring? |
I second H2RTuner. I do not like to risk any particles left behind. |
|
| Author: | Hillclimber [ Mon Jun 13, 2022 7:34 pm ] |
| Post subject: | Re: Before or after boring? |
Thank you to all for replies. Tim: Sent you a pm |
|
| Author: | H2RTuner [ Tue Jun 14, 2022 9:28 am ] |
| Post subject: | Re: Before or after boring? |
Clarification on the Brillo pad. All bead blasting opens the pores of the aluminum, allowing capture of dirt, grime, oils, grease, discoloring the aluminum. The Brillo pad closes those open pores, so adversive stuff doesn't stick, and the aluminum goes back to looking as new. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|