| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| I got the bends http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=14334 |
Page 1 of 1 |
| Author: | RODH2 [ Fri Dec 25, 2020 4:08 am ] |
| Post subject: | I got the bends |
SO....new Barnett clutch, S2 clutch cable, Ralf's amazing brass fine adjustment/ratio release.....works perfectly......!!! Install tank....70% increase in friction, just the bends, come on you guys, we can do this!! (Flat bars, limited space........) 
|
|
| Author: | Jim [ Fri Dec 25, 2020 8:05 am ] |
| Post subject: | Re: I got the bends |
The solution is to go hydraulic. I did 42 years ago. |
|
| Author: | BarryB [ Fri Dec 25, 2020 9:03 am ] |
| Post subject: | Re: I got the bends |
Cool stuff doe xmas!!!!!!!!!!!!!!!! |
|
| Author: | Ja-Moo [ Fri Dec 25, 2020 2:28 pm ] |
| Post subject: | Re: I got the bends |
Just work your routing. |
|
| Author: | AER005 [ Fri Dec 25, 2020 4:31 pm ] |
| Post subject: | Re: I got the bends |
Hi Rod try running the cable around R/h side of steering head , i am using standard cable with fine actuator ,barnet clutch and springs and mine isnt that heavy |
|
| Author: | RODH2 [ Sun Dec 27, 2020 5:54 am ] |
| Post subject: | Re: I got the bends |
Okay, found the perfect route, but I need a cable 4'' shorter than an S series cable! Surprising how much "stiction" there is in a simple blend, even with a mild radius...! I had a Hydro. clutch on my GPZ900R, Jim, but that had a bit more room for the "furniture"!! Bit of dry graphite lube, bit of adjustment, we'll get there! |
|
| Author: | H2RTuner [ Sun Dec 27, 2020 2:10 pm ] |
| Post subject: | Re: I got the bends |
NEVER had a bit of trouble with stock street bike H2 clutch cable, routed correctly, even with 5 Barnett springs and stock 6 run plastic release. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|