Are you also using the "secondary" clamp in conjunction with these?
HOLDER MUFFLER CONECT 18044-007
If you are and it still slips, perhaps you might try applying a thin coating of bed liner to that area, let it dry, then reassemble.
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Those slippery exhaust clamps..... Hack Needed. http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=13080 |
Page 1 of 1 |
| Author: | richfan [ Tue Sep 26, 2017 4:00 pm ] |
| Post subject: | Those slippery exhaust clamps..... Hack Needed. |
Does anyone have any tricks for keeping the 3 exhaust clamps that seal the head pipe/main pipe slip joint from vibrating off? I've cleaned and tightened, and they keep vibrating off. I'm running the Denco stock exhaust replicas from Z1 parts. I did try to put a layer of exhaust wrap over the slip joint first, followed byt he rubber boot, then the clamp. Better, but not an optimal solution. Attachment: clamps.jpg Rich |
|
| Author: | kawi3cyl [ Tue Sep 26, 2017 5:18 pm ] |
| Post subject: | Re: Those slippery exhaust clamps..... Hack Needed. |
Are you also using the "secondary" clamp in conjunction with these? HOLDER MUFFLER CONECT 18044-007 If you are and it still slips, perhaps you might try applying a thin coating of bed liner to that area, let it dry, then reassemble. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|