Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
Carb gaskets http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=13072 |
Page 2 of 2 |
Author: | H2RTuner [ Fri Sep 22, 2017 10:14 pm ] |
Post subject: | Re: Carb gaskets |
ONLY reason I posted is that some other persons might not have understood the correct process, nothing more. The needle seat does need a more firm gasket composition up than the bowl gaskets do. That is the reason I recommended hard fiber washers from good hardware stores. Anyway, you have it dialed in, I am sure. Now, go have fun with it. |
Author: | Chris [ Sun Sep 24, 2017 9:42 pm ] |
Post subject: | Re: Carb gaskets |
H2RTuner wrote: ONLY reason I posted is that some other persons might not have understood the correct process, nothing more. The needle seat does need a more firm gasket composition up than the bowl gaskets do. That is the reason I recommended hard fiber washers from good hardware stores. Anyway, you have it dialed in, I am sure. Now, go have fun with it. Thanks for the input. After your post, I went to my local hardware store (the best one in town), but they didn't have any that small. I'll look around for next time, but for now I'm good. Happy so far, after one ride after installing Ivan's kit. |
Page 2 of 2 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |