| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Flywheel holding tool - what ya using? http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=12845 |
Page 1 of 1 |
| Author: | ihatemybike [ Sat Jun 03, 2017 12:51 pm ] |
| Post subject: | Flywheel holding tool - what ya using? |
Think it's about time I get a proper flywheel holder to use while torquing down the flywheel nut. My flywheel has two semi-circular slots in the face. I see some that are meant for slots (but I think for slots on the side not on the face), some that are meant for pin, and some that claim to be universal. I'm thinking that I should be using a pin type holder, but not certain. What tool(s) are you using? How well do you like them? |
|
| Author: | Ja-Moo [ Sat Jun 03, 2017 12:53 pm ] |
| Post subject: | Re: Flywheel holding tool - what ya using? |
Clean threads, blue locktite, smack the ratchet handle a few times with your hand. Bob is now related....... |
|
| Author: | demus [ Sat Jun 03, 2017 4:05 pm ] |
| Post subject: | Re: Flywheel holding tool - what ya using? |
I have always used a chain vise grip on clutch baskets and magneto rotors and gears without a problem. Impact to loosen the nut. Torque wrench or like John said to tighten. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|