Kawi2strokes.com Forum
http://www.kawi2strokes.com/forum/

H2 misery Part II
http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=12623
Page 5 of 5

Author:  Beetseutler [ Wed Apr 12, 2017 7:30 pm ]
Post subject:  Re: H2 misery Part II

Why didn't you call me?I'd give you a hand and show you a few things.I'm off right now

Author:  Gregz [ Wed Apr 12, 2017 8:47 pm ]
Post subject:  Re: H2 misery Part II

H2RTuner wrote:
LIGHTLY oil, and reinstall the K&N's. Jet from there.


That's funny !

I restored two 72' H2's and had numerous H 1's . Trust me, a light oil on the filters and jetting is not going to make it run. I have done everything possible.

Author:  Gregz [ Wed Apr 12, 2017 8:51 pm ]
Post subject:  Re: H2 misery Part II

Beetseutler wrote:
Why didn't you call me?I'd give you a hand and show you a few things.I'm off right now



What's up Bobby Beatler, Ive been off since Nov. I might take the year off and goof off drink beer and ride bikes (except the H2) Z1's

p.m your number Iv'e done lost it. I call you

Author:  10sec H2 [ Wed Apr 12, 2017 8:54 pm ]
Post subject:  Re: H2 misery Part II

Start over. Stock jugs, stock porting, stock heads, stock carbs, it will run great, it will start up every time. ENJOY.

Author:  H2RTuner [ Wed Apr 12, 2017 10:16 pm ]
Post subject:  Re: H2 misery Part II

I don't think it is funny. You KNOW the K&N's work, eliminate a possible problem by returning them to service.

In your posts, you said the only changes were air filters and pipes, then, jetting.

Not funny one little bit.

Author:  Dewman418 [ Fri Apr 14, 2017 12:57 am ]
Post subject:  Re: H2 misery Part II

I had a real small piece of junk get caught in a jet one time and the start cables/plungers can cause fuel to get by and flood. Just a thought.

Author:  Gregz [ Mon May 08, 2017 7:47 pm ]
Post subject:  Re: H2 misery Part II

Today I dragged the H2 out of the corner and cussed at a it a few times. Pulled the carbs cleaned them once again. I installed 105 mains , stock 40 pilot and checked it's on the 4 clip. this time I installed the K&N pods not the UNI's . Added petrol , a few kicks and it ran perfect. Did a few laps around lake and it's all good .
Next weekend i will install another set of new pugs and put some miles on it and do a few plug checks. Maybe i won;t set it on fire after all

:) :) :)

Page 5 of 5 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/