I have finally gotten around to addressing my tatty old loom on the H1A. I bought a replacement loom from Doremi a couple of years ago and this weekend (eventually
), pulled it from the packet to begin the job. However, it doesn't look exactly the same as the one that is in situ. The colours of some wires used on the repro one are different (to my existing harness and the wiring diagram in the manual) and there are extra wires in some parts. It does have the two wires with no ends on them that I gather are for the CDI - so, I'm guessing it is meant for the bike.
Could someone with more electrical knowledge than me have a look at the pics below and let me know if this correct for the H1A or if I have been given the wrong one? I don't really want to start pulling the old one out until I'm sure I have an appropriate replacement. Shouldn't they be pretty much a plug and play item?
Thanks heaps