| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| H1E rubber motor mount question http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=11948 |
Page 1 of 1 |
| Author: | Jackman [ Fri Jul 22, 2016 5:28 am ] |
| Post subject: | H1E rubber motor mount question |
Finally H1E engine going back in the frame  , question my front motor mounts have serrations on one side and smooth on the other , I assumed they were worn so I bought two other used sets of mounts and they too have serrations on one side and smooth on the other, question is are they all worn out, or is one side smooth the way Kawasaki made the front mounts?
|
|
| Author: | Zambia [ Fri Jul 22, 2016 8:53 am ] |
| Post subject: | Re: H1E rubber motor mount question |
Do you mean that instead of a circular serrated "plug", it has one flat side? So...D-shaped? There are some good pictures in this thread: http://kawasakitriples.myfastforum.org/ ... -asc-0.php |
|
| Author: | Ja-Moo [ Fri Jul 22, 2016 9:10 am ] |
| Post subject: | Re: H1E rubber motor mount question |
I think you have worn out ones, as I remember they are all serrated. One thing, was the rubber is really susceptible to oil and gas and on the low side of the motor the rubbers were usually gooey and flat. Ralf in Germany will sell you just the rubbers. 
|
|
| Author: | Dewman418 [ Sun Jul 24, 2016 6:24 pm ] |
| Post subject: | Re: H1E rubber motor mount question |
 and Ralf yes great stuff
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|