Thats quite a premium for the Denco name on those sprockets.
For comparison, you can get a new pbi aluminum rear 520 size 46 tooth for $57.20 and figure $15 for a new front.
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| 520 sprocket questions http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=1057 |
Page 2 of 2 |
| Author: | oxford [ Mon Sep 19, 2011 6:35 pm ] |
| Post subject: | Re: 520 sprocket questions |
Thats quite a premium for the Denco name on those sprockets. For comparison, you can get a new pbi aluminum rear 520 size 46 tooth for $57.20 and figure $15 for a new front. |
|
| Author: | two-stroke-brit [ Mon Sep 19, 2011 7:08 pm ] |
| Post subject: | Re: 520 sprocket questions |
kawi3cyl wrote: I looked at that but thought it was on the expensive side .am i tight or is that the going rate. oxford you just answered my ?? mark |
|
| Author: | scrambler73 [ Mon Sep 19, 2011 7:20 pm ] |
| Post subject: | Re: 520 sprocket questions |
two-stroke-brit wrote: kawi3cyl wrote: I looked at that but thought it was on the expensive side .am i tight or is that the going rate. oxford you just answered my ?? mark A Titan Tough hard-annodized 520 rear sprocket from Sprocket Specialist out in Cali will set you back around $80.00. The front sprockets are a different story as that pattern was used by a zillion different bikes (yamaha and kawi). When I was in "search mode" while building bikes, I bought a few off of ebay for less than $5.00 each...brand new. so yeah, thats about $40-$50 high. |
|
| Page 2 of 2 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|