Kawi2strokes.com Forum
http://www.kawi2strokes.com/forum/

Fuel line issues
http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=729
Page 2 of 2

Author:  kawi3cyl [ Thu Aug 04, 2011 3:07 am ]
Post subject:  Re: Fuel line issues

Just purchased this 5mm hose (2nd time from same seller). Make sure it'll fit your barbs if you decide to buy.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=380266173504

Consider this as well:

6mm:
http://cgi.ebay.com/Green-Fuel-Gas-Line-6mm-Ducati-Moto-Guzzi-Honda-Yamaha-/160580070800

5mm:
http://cgi.ebay.com/Green-Fuel-Gas-Line-5mm-Ducati-Single-bevel-160-250-350-/380353033615

Author:  bsanorton [ Thu Oct 13, 2011 7:10 am ]
Post subject:  Re: Fuel line issues

late to the game here guys, but I'm new to the kawi triples and need fuel line. Is the correct stock size for a 74' H1 5mm? The line I have on has red marks on it that state 'free flow' is this the original lines?

Author:  mraxl [ Thu Oct 13, 2011 7:41 am ]
Post subject:  Re: Fuel line issues

3/16" is easiest to find.
Stock lines are black with no writing that I can recall... 6mm

Author:  usernameandpassword [ Thu Oct 13, 2011 10:00 am ]
Post subject:  Re: Fuel line issues

*ryan wrote:
same thing happened to me on my s2a

replaced with the same clear line you did
within a year it cracked, and even worse the damn inline filter broke too

thinking about going back to the black rubber fuel line

its been holding up since 67 on my bolens tractors, should last a while on the s2a


I also got the clear, it turned yellow after a couple years and got hard as a rock. The stuff split at bad opportunities, usually while riding, and left my shoes smelling like gas for weeks. I bought some black rubber line from Advance and been running it for the last 3 years without issue......and it's still soft and comes off the spouts good. :thumbup:

Author:  c3RX9 [ Thu Oct 13, 2011 11:11 am ]
Post subject:  Re: Fuel line issues

I got some Tyogon line from an old kart engine builder who had a few reels of hose taking up space.
Threw a few pieces in a jar of gas and left for a week before I tried on the H2, it didnt seem to swell or get gummy, so I put it on.
Within 2 or 3 months, I noticed the lines looked tight as a drum, and were much shorter than when I installed.

The tygon got hard enough to use as an emergency kickstand!

Bought a reel of clear whatever from motionpro and it seems to hold up fine. Turns yellow, but remains in character.

Does anyone need a bunch of 1/4 ID fuel line, I have much of it! :oops:

Page 2 of 2 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/