Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
Bent fork tubes http://www.kawi2strokes.com/forum/viewtopic.php?f=2&t=1535 |
Page 2 of 2 |
Author: | Ric [ Sat Nov 05, 2011 12:56 pm ] |
Post subject: | Re: Bent fork tubes |
I seen it done. They were only slightly bent enough not to fit through the triples. I've also seen bent triple clamps straightened. It's a hassle but if you have the right equipment.... |
Author: | Ja-Moo [ Sat Nov 05, 2011 1:22 pm ] |
Post subject: | Re: Bent fork tubes |
Heym they are shot anyway, good way to learn something new! |
Author: | falconman [ Sat Nov 05, 2011 3:26 pm ] |
Post subject: | Re: Bent fork tubes |
This place has the best quality tubes I have seen. I got my S3 tubes from them. But with a hassle. They have the S3 and KH tubes backwards in their database. They sent me KH tubes and said it was all my fault, I ordered the wrong part. Cost me more to fix their mistake as they insisted it was my mistake. To avoid hassle send them a sample to match. http://www.frankmain.qpg.com/ |
Author: | rotortech [ Sat Nov 05, 2011 4:26 pm ] |
Post subject: | Re: Bent fork tubes |
falconman wrote: This place has the best quality tubes I have seen. I got my S3 tubes from them. But with a hassle. They have the S3 and KH tubes backwards in their database. They sent me KH tubes and said it was all my fault, I ordered the wrong part. Cost me more to fix their mistake as they insisted it was my mistake. To avoid hassle send them a sample to match. http://www.frankmain.qpg.com/ I linked to your thread on the KTW board pretty early in this thread. I feel your pain and will be cautious. |
Page 2 of 2 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |