Hi all, Just got my vm34 carbs for the project 750 and need a tutorial on where to drill and tap the oil line holes in the carbies as I am not running premix fuel any help or links appreciated,Hooter
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| vm34 mikuni mod http://www.kawi2strokes.com/forum/viewtopic.php?f=16&t=8372 |
Page 1 of 1 |
| Author: | HOOTER [ Thu May 01, 2014 4:08 am ] |
| Post subject: | vm34 mikuni mod |
Hi all, Just got my vm34 carbs for the project 750 and need a tutorial on where to drill and tap the oil line holes in the carbies as I am not running premix fuel any help or links appreciated,Hooter
|
|
| Author: | falconman [ Fri May 09, 2014 11:11 pm ] |
| Post subject: | Re: vm34 mikuni mod |
I have not done it myself but basically you use one of the carb bowl vents on the side. If you carbs have two vents use one for the oil fitting. If it has one there should be an undrilled boss on the other side you can drill out. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|