prototype for fitment being printed as we speak.....
then.. soon, some ABS ones if all goes as planned.
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| somethings afoot in sc..... http://www.kawi2strokes.com/forum/viewtopic.php?f=16&t=3899 |
Page 1 of 6 |
| Author: | m in sc [ Thu Jul 19, 2012 5:42 pm ] |
| Post subject: | somethings afoot in sc..... |
| prototype for fitment being printed as we speak..... then.. soon, some ABS ones if all goes as planned. |
|
| Author: | Jim [ Thu Jul 19, 2012 5:52 pm ] |
| Post subject: | Re: somethings afoot in sc..... |
Do I need a set? I just checked... ABS melts at 221° F. |
|
| Author: | m in sc [ Thu Jul 19, 2012 5:55 pm ] |
| Post subject: | Re: somethings afoot in sc..... |
do you? dunno. I'll hopefully be testing them soon. will follow up. |
|
| Author: | Jim C [ Thu Jul 19, 2012 6:34 pm ] |
| Post subject: | Re: somethings afoot in sc..... |
As always; very nice How much cylinder chopping to make them fit? |
|
| Author: | m in sc [ Thu Jul 19, 2012 6:55 pm ] |
| Post subject: | Re: somethings afoot in sc..... |
thats the beauty of it. none. direct bolt on is the plan using stock rd reeds and intakes. |
|
| Author: | m in sc [ Thu Jul 19, 2012 7:01 pm ] |
| Post subject: | Re: somethings afoot in sc..... |
might be a hybrid of plastic when it gets down to final printing. |
|
| Author: | Ric [ Thu Jul 19, 2012 9:31 pm ] |
| Post subject: | Re: somethings afoot in sc..... |
Sweet idea; using standard RD stuff. Makes it an easy bolt on. |
|
| Author: | Ja-Moo [ Thu Jul 19, 2012 9:39 pm ] |
| Post subject: | Re: somethings afoot in sc..... |
What's it for Mark? |
|
| Author: | m in sc [ Thu Jul 19, 2012 10:10 pm ] |
| Post subject: | Re: somethings afoot in sc..... |
s2. easy to mod to s3, h1 though. |
|
| Author: | Jim [ Thu Jul 19, 2012 10:46 pm ] |
| Post subject: | Re: somethings afoot in sc..... |
Darn. |
|
| Page 1 of 6 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|