Kawi2strokes.com Forum

does anyone have a drawing showing the dims of the cutouts on the moo mod rotor.
i only really need the radius or what dia it went out to.
thanks mark

_________________
she will never be pretty but she is a fun ride.

73 KAWASAKI H1 (Sold).
82 YAMAHA RD350LC
2000 KAWI KDX200H
2001 Triumph TT600

Someone might have the drawing, but from my notes I have 32.75mm from the od of the rotor to where the inside of the cut out is. That should make the diameter of the cutout 263.25mm.

I found mine.....

_________________
Twist the throttle, tilt the horizon, and have a great time. What triples are all about...........

thanks i have skimmed it to 5.5mm and if i can sneek in on sat/sun i will mill the cut outs.
cheers mark
as someone said "stock is a crock"

_________________
she will never be pretty but she is a fun ride.

73 KAWASAKI H1 (Sold).
82 YAMAHA RD350LC
2000 KAWI KDX200H
2001 Triumph TT600

Are you going to do the cutouts by cnc or do them manually with a rotary?

Rotary table on the Bridgeport .
Why

_________________
she will never be pretty but she is a fun ride.

73 KAWASAKI H1 (Sold).
82 YAMAHA RD350LC
2000 KAWI KDX200H
2001 Triumph TT600

Pm sent.

done in true "bodgeit and leggit" styley.

thanks every one
cheers mark

_________________
she will never be pretty but she is a fun ride.

73 KAWASAKI H1 (Sold).
82 YAMAHA RD350LC
2000 KAWI KDX200H
2001 Triumph TT600

It's interesting that you went all the way though the aluminum carrier section with the cutter. I know that moo had left some of it there, but I don't really think that it is needed. Did you get a weight on it after the cutouts?

I wondered about that also, but 9 reinforced spokes should be way strong.

_________________
Twist the throttle, tilt the horizon, and have a great time. What triples are all about...........