Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
ROD'S H2 http://www.kawi2strokes.com/forum/viewtopic.php?f=16&t=12373 |
Page 12 of 13 |
Author: | RODH2 [ Sat Feb 25, 2017 2:42 am ] |
Post subject: | Re: ROD'S H2 |
http://www.kenma.com.au/brake_hoses.html Give these guys a call, Baz. I carefully measured the lines allowing for total extension of the forks, etc. and they fit like a glove. You can give them the measurements for three hoses, my top hose is only about 20cm long, given the short flat bars. Only took a week or two to have them made and delivered. I'll put up a pic. of the top hose a bit later. |
Author: | BarryB [ Sat Feb 25, 2017 9:20 am ] |
Post subject: | Re: ROD'S H2 |
I love watching these. Good job - more pics and thanks. |
Author: | BazNSW [ Sat Feb 25, 2017 4:24 pm ] |
Post subject: | Re: ROD'S H2 |
RODH2 wrote: http://www.kenma.com.au/brake_hoses.html Give these guys a call, Baz. I carefully measured the lines allowing for total extension of the forks, etc. and they fit like a glove. You can give them the measurements for three hoses, my top hose is only about 20cm long, given the short flat bars. Only took a week or two to have them made and delivered. I'll put up a pic. of the top hose a bit later. Yeah I have that place in favourites, I'll give them a call and see how much it will cost, I am thinking of not using the splitter and just having the the two hoses, I just want to get rid of the tube at the end and have the hose go straight to the caliper. Thanks Rod. |
Author: | RODH2 [ Mon Mar 13, 2017 12:45 am ] |
Post subject: | Re: ROD'S H2 |
...On to the engine now, and a question for the Electrical gurus....... Due to age, storage, etc. etc. the projections on the front and rear of the Signal Generator I have are not in perfect alignment, the difference is quite visible, perhaps 1/16th". Can I clean them up, and realign them.......is the signal picked up from the front projection, or the rear, or somewhere in the middle, like an average?? I have advanced, marginally, the location of the pin which secures the S.G. rotor to the Rotor, as I am using a Nev. Lush retard ignition system and that will give more timing flexibility. Any thoughts out there on this one...?? (haven't seen this on the forums before!) |
Author: | Ja-Moo [ Mon Mar 13, 2017 1:27 am ] |
Post subject: | Re: ROD'S H2 |
The magnetic strength and the clearance effects when the signal is sent. No real worries, as you can set each pick up separately. A timing light is a must as you probably know. |
Page 12 of 13 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |