| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| non-triple coil question, Kawasaki W1 http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=9070 |
Page 1 of 1 |
| Author: | GUTS [ Sat Aug 30, 2014 8:51 am ] |
| Post subject: | non-triple coil question, Kawasaki W1 |
I was trying to fire up the '66 W1 I have and after doing the test in the manual I found I have a bad coil. Can I use one of the coils from my '76 900 LTD to see if it will fire? If I can't find a decent original coil for it can I use any 12v coil that has two leads and will fit? Thanks |
|
| Author: | mraxl [ Sat Aug 30, 2014 9:08 am ] |
| Post subject: | Re: non-triple coil question, Kawasaki W1 |
Generally, use points coils to replace points coil... CDI coils for CDI. CDI coils will have less than 1 ohm primary while points coils have >2ohms. One exception is early H1 CDI. |
|
| Author: | H2RTuner [ Sat Aug 30, 2014 10:11 am ] |
| Post subject: | Re: non-triple coil question, Kawasaki W1 |
The KZ coil should work just fine, but, don't use the KZ resistor plug caps. |
|
| Author: | GUTS [ Sat Aug 30, 2014 4:09 pm ] |
| Post subject: | Re: non-triple coil question, Kawasaki W1 |
Thanks fellas! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|