Kawi2strokes.com Forum
http://www.kawi2strokes.com/forum/

instructional video of assembling a H2 bottom end
http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=8654
Page 2 of 2

Author:  Ja-Moo [ Wed Aug 13, 2014 2:29 pm ]
Post subject:  Re: instructional vidio of assembling a H2 bottom end

Unless you have the wrong rings I don't know why.
are you sure all the holes in the bearings are lined up?

Author:  triple cranks [ Thu Aug 14, 2014 10:19 am ]
Post subject:  Re: instructional vidio of assembling a H2 bottom end

With the parts out of the case try to fit the retainers on the bearings and then in the case independent of each other. Also be sure the locating pins are lined up with the holes in the bearing collar for the transmission shafts. If you are not careful these can easily be pushed into the case.

Author:  docrick [ Fri Aug 15, 2014 1:51 am ]
Post subject:  Re: instructional vidio of assembling a H2 bottom end

thats what I'm gonna do now is try to see why the clips don't wanna sit down all the way. all of the tranny collars are lined up with the holes and the kicker collar as is lined up and sitting in nicely as well. ill post a few pics tonight or in the morn. luckily i didn't pull the motor out of my bike yet so instead of playing hammer mechanic i went fort a ride on this cool night. ahhhhhhh

Author:  BBP [ Thu Oct 02, 2014 10:01 am ]
Post subject:  Re: instructional vidio of assembling a H2 bottom end

John

Thank You so much for the video's on building, I watched them several times, made a bunch of notes and rounded everything up........mad e rebuilding the engine myself not that difficult..........would have been lost without them :!:

Shift Drum Install
Transmission
Shifter #1
Shifter #2
Engine Cases
Right Side

Strange.....I was missing the same exact small stud in the front that you were :shock: ........It's in there now, whats the chance of that ?

THX Phil

Image

Author:  Ja-Moo [ Thu Oct 02, 2014 1:06 pm ]
Post subject:  Re: instructional vidio of assembling a H2 bottom end

You are welcome Phil, and i just put in a allen bolt, I'm lazy.......lol

Author:  BBP [ Fri Oct 03, 2014 9:17 am ]
Post subject:  Re: instructional vidio of assembling a H2 bottom end

Yep, I took a stud out of my old cases ;)

Oh......and I meant KickStarter 1........and KickStarter 2........(not shifter 1 & 2) :oops:

THX again.....Phil

Page 2 of 2 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/