| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Something wrong in this picture? http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=4874 |
Page 1 of 2 |
| Author: | Ja-Moo [ Thu Nov 08, 2012 1:12 am ] |
| Post subject: | Something wrong in this picture? |
|
|
|
| Author: | Looney Cylinders [ Thu Nov 08, 2012 1:47 am ] |
| Post subject: | Re: Something wrong in this picture? |
You've omitted the spacer plate that is supposed to go with the base gasket(s)??  Looks like you may be contacting Lani for a custom thickness base gasket or head gasket.....  J |
|
| Author: | RODH2 [ Thu Nov 08, 2012 2:33 am ] |
| Post subject: | Re: Something wrong in this picture? |
Did your cat build that engine............? 
|
|
| Author: | Ja-Moo [ Thu Nov 08, 2012 3:34 am ] |
| Post subject: | Re: Something wrong in this picture? |
RODH2 wrote: Did your cat build that engine............? Those are my QC stickers........ And there are no spacers........ 
|
|
| Author: | Hal [ Thu Nov 08, 2012 4:35 am ] |
| Post subject: | Re: Something wrong in this picture? |
It's not a left barrell where a left one should be? It's too shiney for you, too, moo? |
|
| Author: | RODH2 [ Thu Nov 08, 2012 4:44 am ] |
| Post subject: | Re: Something wrong in this picture? |
It's a H1-R engine - 3 centre barrells................!? |
|
| Author: | Steve [ Thu Nov 08, 2012 8:48 am ] |
| Post subject: | Re: Something wrong in this picture? |
The fleck of dirt on the 4th fin down is not centered exactly, if that it? The gouge in the left side engine cover mating surface? OK, I've seen decked cylinder blocks present the same issue, and either a spacer or thicker base gaskets are used. Then again, maybe it's a stroker crank! 
|
|
| Author: | ZERO [ Thu Nov 08, 2012 11:45 am ] |
| Post subject: | Re: Something wrong in this picture? |
I saw a similar thing years ago when someone convinced me that certain snowmobile pistons would fit. they did, and the piston pin was in a different location. 
|
|
| Author: | Ric [ Thu Nov 08, 2012 5:42 pm ] |
| Post subject: | Re: Something wrong in this picture? |
I's not a a kawasaki cylinder....looks too tall. |
|
| Author: | Ja-Moo [ Fri Nov 09, 2012 12:57 am ] |
| Post subject: | Re: Something wrong in this picture? |
I'm at a bit of a loss on this one. The cylinders were decked so much the piston is 1mm proud, and the heads are step cut 1mm. I have only seen this when trying to compensate for too much port timing, but the timing is very mild. So it's not making a lot of sense................ 
|
|
| Page 1 of 2 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|