Kawi2strokes.com Forum

Enthusiasts from around the world dedicated to the preservation and ritual flogging of the infamous Kawasaki 2-stroke Triples
It is currently Sat Apr 27, 2024 3:27 pm

Board index » Our legendary Kawasaki Triples » Troubleshooting, How-to, and General Wrenching

All times are UTC - 5 hours




Post new topic Reply to topic  Page 2 of 2
  [ 12 posts ]  Go to page Previous  1, 2
  Print view Previous topic | Next topic 
Author Message
11cycle
 Post subject: Re: drill and tap size
PostPosted: Sat Apr 14, 2012 3:07 pm 

Joined: Sat Jun 11, 2011 7:22 pm
Posts: 143
Location: chazy,ny
Image
Nigel,since there is a crack next to the stud,I figure it is best to fill this one with weld.So why not drill and tap?
Top
 Profile  
 
Nigel72iv
 Post subject: Re: drill and tap size
PostPosted: Sat Apr 14, 2012 6:40 pm 

Joined: Thu Jun 09, 2011 8:26 am
Posts: 399
Location: Melbourne, Australia
That's much more damaged than I was thinking. Welding and retaping is the way to go there.
If it was just stripped an insert would be easier.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 2 of 2
  [ 12 posts ]  Go to page Previous  1, 2

Board index » Our legendary Kawasaki Triples » Troubleshooting, How-to, and General Wrenching

All times are UTC - 5 hours


Who is online

Users browsing this forum: H2RTuner

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group