mraxl wrote:
Likely a bad ground (earth) on the blinker stem.
almost guaranteed to be
| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Back left blinker not working http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=2259 |
Page 1 of 1 |
| Author: | 350ernie [ Mon Jan 30, 2012 5:54 am ] |
| Post subject: | Back left blinker not working |
Here I go again askign for help on my KH500. Back right blinker does not flash. Yep the globe is good, check on battery. Checked the contact point on the globe with a volt mteer and it went from about 3 volts ? to 14 volts ? and back again as flasher unit flashed. The flasher unit is new. AND when I put the wire to the back right blinker to the back left blink and turn the blinkers to the left , the front left blinker blinks and the back right blinker blinks. Help ! |
|
| Author: | mraxl [ Mon Jan 30, 2012 6:53 am ] |
| Post subject: | Re: Back left blinker not working |
Likely a bad ground (earth) on the blinker stem. |
|
| Author: | olde coney [ Mon Jan 30, 2012 7:40 am ] |
| Post subject: | Re: Back left blinker not working |
mraxl wrote: Likely a bad ground (earth) on the blinker stem. almost guaranteed to be
|
|
| Author: | Iron [ Mon Jan 30, 2012 9:30 am ] |
| Post subject: | Re: Back left blinker not working |
Run a short wire from the body of the blinker to a good ground and check it out. |
|
| Author: | 350ernie [ Tue Jan 31, 2012 4:29 pm ] |
| Post subject: | Re: Back left blinker not working |
yep that was it . NO EARTH on the blinkert stem. Too much powder coating. |
|
| Author: | BarryB [ Tue Jan 31, 2012 7:13 pm ] |
| Post subject: | Re: Back left blinker not working |
Glad you found it. I'll close this post by saying I use my Back-left blinker wire and handle bar switch (with bypassed clicky thing) to power my running light on the back.
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|