| Kawi2strokes.com Forum http://www.kawi2strokes.com/forum/ |
|
| Front wheel Spindle - How does it fi? http://www.kawi2strokes.com/forum/viewtopic.php?f=14&t=14993 |
Page 1 of 1 |
| Author: | 3pinplug [ Sun Mar 10, 2024 5:10 am ] |
| Post subject: | Front wheel Spindle - How does it fi? |
Hi all i am having only whatI can describe as a "senior mement"!!! as I cannot get the front wheel / spindle to work when i fit it. I have it attached as per the pics, but when i tigthen the castle nut the spindle from the other side simple pulls through the fork leg, even when i have the bolt on the bottom of the forkleg tight. There is a circular spacer which i have put under the oil seal cover (right hand side), is that where the spacer goes or should it go between the forkleg and the hub? Its a 1975 S1C with twin leading shoes, can anyone help and advise how it fits back together? |
|
| Author: | mraxl [ Sun Mar 10, 2024 5:25 am ] |
| Post subject: | Re: Front wheel Spindle - How does it fi? |
https://docs.google.com/viewer?url=http ... s%2Fs1.pdf pg37 |
|
| Author: | 3pinplug [ Sun Mar 10, 2024 6:42 am ] |
| Post subject: | Re: Front wheel Spindle - How does it fi? |
Hi Mraxl, thanks for posting up the parts list, much appreciated. It looks like i have all the parts correct but when i tighten the castle nut it pulls the larger diameter end of the spindle towards it through the round opening of the bottom of the fork, what am i missing that allows you to tighten the castle nut without the spindle being pulled towards it, ideally i should be tightening the castle nut and everything moves towards the other end of the wheel spindle with the hole in it. |
|
| Author: | mraxl [ Sun Mar 10, 2024 12:28 pm ] |
| Post subject: | Re: Front wheel Spindle - How does it fi? |
Snug the castle nut without overtightening and put the pin thru it. Then clamp the axle. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|