Kawi2strokes.com Forum

I had to dremel off the rusted seat molding bolts in order to have it recovered. I want to reinstall the trim so what should I use as a replacement. This is on my Suzuki T 250. Thanks.

Kaw... not Suzi but I used #4 flat head screws.

_________________
Answers are here: http://kawatriple.com/

Similarly, I used #2-56 screws on my H2 seat trim.

_________________
If it surges, that's normal, upshift.

That may be what I used also... trusting memory from 15yr back and I'm getting old

_________________
Answers are here: http://kawatriple.com/

Ha... it must have been 1979 when I made a new seat cover for my H2. I didn't like the original patterned vinyl cover because it was ripping along the waffle lines, so I wanted a plain vinyl cover. That cover is still holding up fine.

_________________
If it surges, that's normal, upshift.

Thanks fellas. I remember on the old forum where this was discussed. That was a long time ago. I will give those screw sizes a try.

Where you at Buddy??????

_________________
Iron On The Bayou.